6. Remember to remind the operator not to "clean up" the hot nozzle at the gate. If the operator happens to see a small piece of stainless steel at the nozzle of the mold fitting, it may be a nozzle a... read more
Thimble is a plastic mold accessory used in plastic molds. The thimble can also be called a push pin, inlay, middle needle, or needle. Sometimes the tip of a lathe is also called a thimble. Use of thi... read more
The defense method of the mold often encounters the problems of the pouring system, the overflow system, the horizontal runner, the gate and the overflow groove in the die casting production. G... read more
3. Gate ① The parting surface should not be closed immediately after the metal liquid enters the mold. The overflow groove and exhaust groove should not directly impact the core. After the flow o... read more
There are many factors that affect the production life of the punch: ① The first is whether the selection of the raw materials of the punch is reasonable, and whether the materials used by the punch m... read more
English
简体中文